|
|
2020 initial problems transferred to 2021 white 1) rusted body in several places: Floor side, Fenders 2) need convergence adjustment after change of arms (bent) 3) Steering boot damaged -> replace 4) CV boot damaged -> replace 5) shock absorber boot damaged -> replace 6) right front clearance lamp side -> done 7) not stable engine idle 8) strange sound with Rear selector position 9) paint and install rear wing -> now installed unpainted (black) 10) tail lamp: 1 stop, 2 rear clearance 11) windshield wipers slow and rusty 12) steering backlash 13) missing one nut rear lamp W=10 |
|
|
2022 white EXY10: rear left wheel blocked nut cracked - drilled out bolt /90942-02047 installed new bolt 2022-04-30 /90942-02049 same as front /90942-02082 - done, nut installed wheels are normal now brakes are not enforced enough
bolt_90942-02047.jpg (57,296 bytes) |
|
|
2024: Sera (white): left front CV dustcoat, or assy, starter with wiring (relay), oil temp switch + connector, TPS + seal, VSV, exhaust pipe gaskets, shock absorber dustcoat, steering arm dustcoat, hood hinge right |
|
|
2024-08-15: Missing high-voltage coil resistive cord /90919-13388 -> made by hand from old good 2pcs spark plug cords, R=6 kOhm L=33 cm Measured cords in 1 and 4 (2pcs spark plug cords) cylinder are bad, replace Cords 2 and 3 have R=9 kOhm Oil pressure light on, cleaned switch /83530-30080 , 0.3P, but problem appeared below Not applicable: Missing filter gas /90917-10080 on SERA03 line from throttle to 3rd body VSV (triple top line) 2024-08-19: Rusted hole in oil pan /12101-11010 /12101-11011 /12101-11012 welding or replacement still shows malfunction 0000201 Ox1 =0V and shorted to frame (B-) GND -> possibly ECU burned, on sensor wire is multilayer red+black |
- Anonymous