|
|
2020 initial problems transferred to next year: 2021: EXY10 (w): W01) rusted body in several places: Floor side, Fenders W02) need convergence adjustment after change of arms (bent) W03) Steering boot damaged -> replace later W04) CV boot damaged -> replace W05) shock absorber boot damaged -> replace W06) right front clearance lamp side -> done 2021 W07) not stable engine idle W08) strange sound with Rear selector position W09) paint and install rear wing -> now installed unpainted (black) W10) tail lamp: 1 stop, 2 rear clearance W11) windshield wipers slow and rusty W12) steering backlash W13) missing one nut rear lamp W=10mm |
|
|
2022: Sera EXY10 (w): W25) rear left wheel blocked (rusted brakes) -> released W26) nut cracked - drilled out bolt /90942-02047 -> done W27) installed new bolt 2022-04-30 /90942-02049 same as front /90942-02082 - done, nut installed - wheels are normal now W28) brakes are not enforced enough
bolt_90942-02047.jpg (57,296 bytes) |
|
|
2024: Sera (w): W36) left front CV dustcoat, or assy, W37) stable starter with wiring (relay for puller), W38) oil temp switch + connector, engine front near radiator W39) TPS + seal, W40) VSV, unknown data W41) exhaust pipe gaskets near sensor (front) two rings -> replaced 2025-09-13 W42) shock absorber dustcoat, W43) steering arm dustcoat right, W44) hood hinge right -> 2025-09-13 released by compressed air and spray grease |
|
|
2024-08-15: W45) Missing high-voltage coil resistive cord /90919-13388 -> made by hand from old good 2pcs spark plug cords, R=6 kOhm L=33 cm Measured cords in 1 and 4 (2pcs spark plug cords) cylinder are bad, replace Cords 2 and 3 have R=9 kOhm W46) Oil pressure light on, cleaned switch /83530-30080 , 0.3P, but problem appeared below Not applicable: Missing filter gas /90917-10080 on SERA03 line from throttle to 3rd body VSV (triple top line) 2024-08-19: Rusted hole in oil pan /12101-11010 /12101-11011 /12101-11012 welding or replacement still shows malfunction 0000201 W47) Ox1 =0V and shorted to frame (B-) GND -> possibly ECU burned, on sensor wire is multilayer red+black |
|
|
2025: W51) replaced oil pan from donor and engine oil new -> 2025-09-11 done W52) Cylinder 01 wire is too short, get new wire high-voltage and need R=7-9 kOhm W53) rusty petrol filter -> replace new W54) rear bumper position adjust accident push W55) left door malding near window glue unstick W56) mirror frame damaged right: replace and paint W57) mirrors electric control: don't work to right side 0000096 W58) right seat broken: restore frame W59) fuel tank gauge wrong level on dashboard: arrow lower than real |
- Anonymous